Portwest ST40 BizTex Microporous Coverall Type 5/6

Portwest ST40 BizTex Microporous Coverall Type 5/6

Portwest

Product Code:  ST40
Brand:  Portwest


Portwest Biztex Micro Anti Static Coverall Range

The Portwest ST40 offers a spacious design guarantees which good fit and will not limit job performance. Made up of millions of polyethylene fibres that are spunbonded giving an excellent barrier, toughness and strength in all directions. Elasticated hood, ankles, cuffs and waist, along with a two-way front zip and sealable front flap.

Sold as a Carton ONLY, 50 units per Carton.

    

Fabric:

BizTex Microporous, 60g

Features:

  • CE certified
  • Elasticated hood, ankles, cuffs and waist
  • Two-way front zip and sealable front flap
  • Low linting construction for minimal contamination
  • Excellent liquid and particulate barrier protection
  • Two-way zip for quick and easy access
  • Ergonomically shaped hood for a perfect fit
  • Anti-static
  • Hood for added protection against the elements

Chemical Protection

Indicates compliance with currect European standards for chemical protective clothing.

EN 13982:2004 Type 5

Dry particle suit. This specifies the minimum requirements for chemical protective clothing resistant to penetration by air borne solid particles. Protects against hazardous dust and dry particulars

EN 13034:2005

Protective Clothing Against Liquid Chemicals

Performance requirements for chemical protective clothing offering limited protective performance against liquid chemicals (Type 6 and Type PB [6] equipment). This stamdard specifies the minimum requirements for limiter use and re-useable limited performance chemical protective clothing. Limited performance chemical protective clothing is intended for use in cases of a potential exposure to a light spray, liquid aerosols or low pressure, low volume splashes, against which a complete liquid permeation barrier (at a molecular level) is not required.

The Standard covers both chemical protective suits (Type 6) and partial body protection (Type PB [6]).

Type 6 suits are tested using a mist or fine spray of water with a dye added to aid the assessment of leakage. The test subject wears an absorbent suit underneath the one to be tested, which absorbs any leaks and is stained by the dye.

Success or failure is determined by measuring the total area of any stains on three suits and comparing this with the requirement. A range of other tests is specified, including resistance to abrasion, tear strength, tensile strength, resistance to puncture, resistance to ignition, resistance to penetration by liquid chemicals and seam strength. In the test for liquid chemical repellency and resistance to penetration by liquid chemicals, a bank of four test chemicals is given in the standard although the requirement is that the suit material demonstrates adequate repellency and resistance to penetration against one chemical from the list.

EN1149 -5

Protective Clothing against the Thermal Hazards of an Electric Arc

This European Standard is part of a series of standards for test methods and requirements for electrostatic properties of protective clothing. The standard specifies material and design requirements for garments used as part of a total earthed system, to avoid incendiary discharges. The requirements may not be sufficient in oxygen enriched flammable atmospheres. This standard is not applicable for protection against mains voltages.

EN 1149 consists of the following parts:

EN 1149-1: Test Method for measurement of surface resistivty.

EN 1149-2: Test Method for measurement of the electrical resistance through a material (Vertical resistance)

EN 1149-3: Test Methods for measurement of charge decay.

EN 1149-4: Garment Test (under development)

EN 1149-5: Material Performance and design requirements.

Electrostatics dissipative protective clothing shall be able to permanently cover all non-complying materials during normal use. Conductives parts (Zips, Buttons etc) are permitted provided they are cover by the outermost material when in use.

EN 14126:2003

This specifies the requirements and test methods for limited use protection against infective agents.

Nuclear Particle

EN1073-2:2002

Protective Clothing against radioactive contamination. Requirements and test methods for non-ventilated protective clothing against particulate radioactive contamination

Chest XS S M L XL XXL XXXL
Inches 32 - 33 - 34 36 - 38 40 - 41 42 - 44 46 - 47 - 48 50 - 52 54 - 55
CM 80 - 84 - 88 92 - 96 100 - 104 108 - 112 116 - 120 - 124 128 - 132 136 - 140
Euro 40 - 42 - 44 46 - 48 50 - 52 54 - 56 58 - 60 - 62 64 - 66 68 - 70

Size guide produced by manufacturer.


Discounts

Add more items to your order for greater discounts, these apply to every product in all clothing categories.

1+
£115.98
5+
£113.08
SAVE 2.5%
20+
£110.18
SAVE 5%
50+
£107.28
SAVE 7.5%
100+
£104.38
SAVE 10%
Size

FROM
£115.98 (£139.18 inc vat)

Add to Basket to view your discounts

+
Product Reviews

Be the first to Write a Review for this item!

Customer Reviews
Rating:  
great product
Sunday, 21 October 2018  |  David

phones the office and was desperate for these to arrive the next day and the next day they did arrive especially for the event. Much appreciated your support will order again


Rating:  
very good
Monday, 15 October 2018  |  Nicolae

very good ,recomanded!


Rating:  
My favourite work shirt
Friday, 12 October 2018  |  Marie

I love this top, so comfortable and the sizing is spot on. Great to finally find some decent hi vis for Ladies. Dries quickly. I will be buying more.


Rating:  
Excellent, polite and helpful service
Wednesday, 10 October 2018  |  Michael

would always now use BK due to their efficiency and speed...


Rating:  
Good
Tuesday, 9 October 2018  |  Andrew

It is good quality, comfortable and light, I would buy another